Updating The Device List; Character Grid - Teledyne TIENet 301 Installation And Operation Manual

TIENet® 301 pH/Temperature Device
Section 2 Installation and Setup for Signature
2.2.1 Updating the Device
List
3 0 1 p H
A
O
c d e f g h i
q
@ # $ % ^ & *
> ? ,
Figure 2-8 Character grid
2-8
When the 301 is physically added to the system, select Perform
Scan so that the flow meter detects it. When the scan is complete,
the 301 appears in the list of connected devices, ready to be con-
figured with the steps shown in Figure 2-9 on the following page.
Note
From the Hardware Setup menu, "Configure" refers to defining
and selecting the parameters for each connected device.
The default parameters that will appear for the 301 device are:
301 pH – pH reading
301 Temperature – Degrees C
The name of any parameter can be changed by highlighting it
and pressing Enter (
igate the grid using the arrow keys. Select characters with Enter
and clear characters with Delete (
Done
Cancel
B C D E F G H I J K L M N
P Q R S
r s t u
.
) to display the character grid. Nav-
T U V W
j k l m n o p
v w x y z
) - _ + = <
(
).
X Y Z a b
/ : !