Teledyne TIENet 301 Installation And Operation Manual page 16

TIENet® 301 pH/Temperature Device
Section 2 Installation and Setup for Signature
Figure 2-5 Position and secure the cable
2-4
5. Gently tug the cable downward, to remove any slack within
the enclosure, taking care not to put any stress on the con-
nection.
6. Tighten the cord grip sealing nut.
7. Close the front panel and fasten it shut with the two Phil-
lips screws.
If you are using conduit instead of the cord-grip fitting, the con-
duit must be sealed to prevent harmful gases and moisture
from entering the Signature enclosure. Failure to seal conduit
could reduce equipment life.
CAUTION