Procedure For Setting-Up The Doors; Correct Position Of Cable Compartment Doors; Doors Gasket - ABB UniGear ZS1 Installation, Operation And Maintenance Instructions Manual

28 U n i G e a r Z S 1 I N S T A L L A T I O N , O P E R A T I O N A N D M A I N T E N A N C E

5.4 Procedure for setting-up the doors

Closing of doors could be problematic in some
cases. To avoid problems with doors closing
the following shall be fulfilled and followed:
If switchgear is installed properly the doors
shall be in the position in which the upper edge
of door will be parallel with the gap between
the circuit breaker compartment and the low
voltage control cabinet.
—
Figure 30 Correct position of cable compartment doors
Doors gasket shall be installed in correct
direction (3 tooth on inner side and 1 tooth of
the gasket on outer side).
—
Figure 31 Doors gasket