Sliding Part Of Doors Locking Mechanism; Guiding Screws; Guiding Screw; Doors Closing - ABB UniGear ZS1 Installation, Operation And Maintenance Instructions Manual

A S S E M B L Y O F T H E S W I T C H G E A R O N S I T E
Sliding part of the doors locking mechanism
shall not be bended (could happen because of
wrong and rough closing operation).
—
Figure 32 Sliding part of doors locking mechanism
If guiding screws after loosing still don't reach
end position, then it'a necessary to replace the
handle.
—
Figure 34 Guiding screw
If guiding screws in open position of handle
don't reach end position, it's necessary to
loose a bit screws.
—
Figure 33 Guiding screws
Doors shall be closed by both hands.
—
Figure 35 Doors closing
29