Download
Share
Print this page
  1. Manuals
  2. Brands
  3. ClearWater Lights Manuals
  4. Motorcycle Accessories
  5. Glenda
  6. Installation manual

ClearWater Lights Glenda Installation Manual

Bmw s1000r/rr led light kit
Hide thumbs Also See for Glenda:

Advertisement

Quick Links

Download this manual

Advertisement

loading
Need help?

Need help?

Do you have a question about the Glenda and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for ClearWater Lights Glenda

Summary of Contents for ClearWater Lights Glenda

  • Page 2 (916) 852-7029. Please take the time to review the included instructions. Installation of your new Clearwater Lights is straightforward. But, be sure to follow some of the suggestions to keep the installation safe and reliable. If you have any questions or comments, please feel free to contact us.
  • Page 3 Installation Tips: There are two main parts to the installation of your new Clearwater Lights. The mechanical portion, and the electrical portion. With this manual, we will go over the basics of both which should allow you to get your lights up and running. If you purchased a bracket made...
  • Page 4 Step 2: Mounting The Lights / Fork Mount Mounting The Lights: (Fork Mount) Pre-assemble the lights, mounting bracket, shoulder washers and spacers with new bolts. Gently screw all bolts in hand tight. Inspect the bolt length and spacer alignment before tightening the bolts. D41/G41 Fork Kit #14 Spacer (Small) #14 Spacer (Small)
  • Page 5 Step 3: Disassembly Disassembly Step 1. Remove seat (2 screws at rear of seat) Step 2. Remove rear seat (insert key and turn key 90 degrees to remove) Step 3. Remove right side body panel (follow diagram below which can also be found on pg.
  • Page 6 Step 3: Disassembly Disassembly Step 4. Remove upper right side body panel Step 4. Step 4. Screw under seat Screw under seat needs to be removed needs to be removed Plastic clip under fairing Plastic clip under fairing here needs to be gently here needs to be gently popped out of the socket.
  • Page 7 Step 3: Mounting The Volume Control Knob Mounting The Volume Control Knob: (Bar Mount) • Mount the Volume Control Knob to handlebar by using supplied bracket and bolt to the existing controls. • Route wires from lights and volume control knob bracket to area under left side of forks.
  • Page 8 Step 4: Wiring Wiring: • We highly recommend you take a minute to review the wiring diagram below before starting the wiring portion of the installation. Once you feel comfortable with the information below you are ready to begin the electrical portion of the installation.
  • Page 9 Step 4: Wiring Wire Routing: • Be sure to route wires so that they cannot become tangled or caught in either a suspension part or steering part. Check movement of both steering and suspension before riding the bike. • It is sometimes helpful to follow existing wire routing. Wiring: •...
  • Page 10 Step 5: Alignment / Drip Loop Instructions Aligning The Lights: Adjustment is up to the user depending on his needs. Ask an assistant to help you with this procedure. Make sure the bike is on level ground and have an assistant sit on the bike. With a right angle board or object, position the board on the floor and slide it up to the light.
  • Page 11 Notes: Notes: Page 11 Page 10...
  • Page 12 Revised on 7/23/20...

This manual is also suitable for:

Darla