Setting the Zoom Motion Range
] or [
] to zoom out and zoom in, respectively.
] to zoom in until the lens's wide-angle end and
then click [Wide-angle Limit] to confirm the motion limit.
Similarly, click [
end and then click [Telephoto Limit] to confirm the motion
Click [Save] to save the motion range values.
Operations with the Motion Range Settings
Motion range settings refers collectively to the set of pan, tilt, roll and zoom motion range values for both upright
position and underslung position.
Removing the Camera Head's Motion Range Limits
Click [Remove Limit] to remove all the camera head's motion range limits and enable operation beyond the limits that
were set. The changes are not saved to the IP controller. However, the current motion range adjustments displayed on
the screen are maintained so this is a convenient way to change only some of the motion range limit values.
Resetting the Motion Range Limits
Click [Clear] to reset the motion range limits to their initial values. Use this option to clear the motion range limits for all
axes and start over.
Importing Motion Range Limits
Click [Import] to import all the motion range settings from a previously saved file and save the changes to the IP
Exporting Motion Range Limits
Click [Export] to save the all current motion range settings currently saved on the IP controller to a file (.JSON format).
Saving Motion Range Limits
Click [Save] to save the current motion range settings displayed on the screen to the IP controller.
] to zoom out until the lens's telephoto
Setting the Camera Head's Motion Range