Siemens RDS110.R User Manual page 34

6
Operating the thermostat on the device
Advanced settings
Other settings
34 | 59
No. Application Descriptions
settings
35. Off/protection Configures whether
configuration the thermostat goes
to the protection
mode or completely
turns off in "OFF"
mode.
36. Heating Indicates a different
control loop time for PWM
(Pulse Width
Modulation) pulse
periods. You can
select the default
setting to let the
system configure
the most suitable
heating controller
settings based on
your selected
equipment type.
37. Floor Floor temperature
temperature limit for electric floor
limit heating
38. Optimum start Pre-heats the room
control in an optimum way
so that you can get
the scheduled
temperature
setpoint at your
scheduled occupied
time. You can
choose "Warm-up
gradient" to
manually define the
warm-up speed, or
choose "Self-
adaptive" to let the
thermostat learn
and decide the
warm-up speed.
39. Warm-up The warm-up speed
gradient that you set to pre-
heat the room.
Factory Range
settings
Protection Off
Protection
Default Slow
Medium
Default
Fast
2-position
Self-
adaptive
40 °C 35...60 °C Valid only if
Warm-up Warm-up
gradient gradient
Self-
adaptive
30 min/K 0...120 mi
n/K
A6V11562455_en--_b
Dependencies
N/A
N/A
you've
selected the
equipment type
as "Electric
floor heating"
and enabled
the floor
temperature
input in
Changing
system setup
[➙ 35].
Visible only if
you've
activated the
optimum start
control settings
in Changing
system setup
[➙ 35].
Valid only if
you've
activated the
optimum start
control settings
in Changing
system setup