Connecting To Wireless Devices; Overview Of Connected Devices - Siemens RDS110.R User Manual

5 Connecting to wireless devices

5.1 Overview of connected devices

A6V11562455_en--_b
Acting as a Thread router, the thermostat can connect to a maximum of six
wireless relays (RCR114.1) or valve actuators (SSA911.01TH) to control your
heating system remotely. If a relay or actuator fails to connect to the thermostat
due to low signal strength (distance or blockades [walls, and so on.]), you can
install a maximum of three wireless repeaters (RCR114.1) in between to extend
the reach of the RDS110.R control signals.
Once the connection between the thermostat and the wireless devices has been
established, no manual re-connection is needed, even if a power supply
interruption should occur.
NOTICE
●
You cannot manually turn ON/OFF RCR114.1.
●
RCR114.1 and SSA911.01TH cannot be connected to the thermostat at the
same time unless RCR114.1 is configured as a repeater. See the
of RCR114.1 for information about how to configure it as a repeater.
●
If pairing fails the first time, wait five minutes before trying again.
1 Tap to change name and see valve position (SSA911.01TH only)
2 Wireless repeater (RCR114.1 only)
3 Relay or actuator (RCR114.1 or SSA911.01TH)
4 Signal strength of the connected device
5 Tap to remove a device.
6 Communication failure
7 Low battery (SSA911.01TH only)
8 Tap to view all devices.
9 Tap to add more devices.
Connecting to wireless devices
Overview of connected devices
5
Quick guide
17 | 59