Siemens RDS110.R User Manual page 32

6
Operating the thermostat on the device
Advanced settings
Functions
Temperature offsets
32 | 59
No. Application Descriptions
settings
24. Kick cycle A circle kicked in to
turn on a constantly
idle pump or valve for
a minimum period of
time to protect the
pump or valve from
being locked up. You
can set the kick-in
time interval by
yourself; however, the
minimum time period
the pump or valve is
switched ON depends
on what heating
controllers setting
you've selected.
25. Presence Allows switching to
detector "Comfort"
automatically if an
unoccupied room is
detected to be
occupied when a
scheduled
"Unoccupied" mode is
running.
No. Application Descriptions
settings
26. Built-in Temperature offset
temp. value for the built-in
sensor adj. room temperature
sensor.
27. Room Temperature offset
temp.1, value for the room
measured temperature sensor
value adj. connected in terminal
X1.
28. Room Temperature offset
temp.2, value for the room
measured temperature sensor
value adj. connected in terminal
X2.
Factory Range
settings
500 h 1...8760 h
Inactive N/A
Factory Range
settings
0 K -5...5 K
0 K -5...5 K
0 K -5...5 K
A6V11562455_en--_b
Dependencies
Application
setting No. 38;
This function
displays only if
you select the
equipment type
as one of the
following in
Changing
system setup
[➙ 35]:
Radiator with
valve,
Radiator with
pump, Floor
heating with
valve or Floor
heating with
pump.
An external
presence
detector
sensor must be
connected to
the thermostat
using terminal
X1or X2.
Dependencies
Valid only if the
built-in
temperature
sensor is used
to measure the
temperature.
Valid only if an
external room
temperature
sensor is
connected
using X1.
Valid only if an
external room
temperature
sensor is
connected
using X2.