Download Print this page

Mounting The Compressor - Air Lift Load Controller I Manual

Advertisement

Figure 2
Figure 3
Push-To-
Connect Fitting
Hose
Figure 4
2
I. Mounting the Compressor
1. Select a rigid convenient mounting location on the frame or in a
storage area. The location selected should shield the
compressor from the elements. IMPORTANT: Be careful to
shield the compressor from heat sources. Do not mount the
compressor in the engine compartment. Doing so can cause
Mounting Bolt
premature failure to the compressor
Flat Washer
2. Using the mounting holes on the compressor legs as a guide,
mark the mounting hole locations.
Vehicle Body
3. Remove the compressor and center punch and drill four
Flat Washer
diameter holes.
Star Washer
Nut
4. Use the supplied screws and nuts to mount the compressor
(Figure 2).
5. Attach the air filter to the inlet port at the back of the compressor
(Figure 3).
6. Install the fitting into the pressure port side of the leader hose
(Figure 4).
II. Mounting the Dash Panel
1. Select a convenient, sturdy mounting location for the gauge
panel.
2. Using the gauge panel mounting bracket as a template, position
the gauge panel to the mounting surface.
3. Secure with two self-tapping screws.
III. Wiring the Electrical Connections
1. Install the yellow ring terminal to the compressor motor ground
(black) wire. Select a good ground location, and attach the ring
terminal with the self-tapping screw provided.
2. Determine the length of supplied (red) wire required to connect
the dash panel to the compressor.
3. Connect the (red) wire from the panel to the (red) wire on the
compressor using a blue butt connector (Figure 1). Connect the
other end of the wire to the push switch using the blue
push on connector. With your thumb against the front side of
the switch, push the connector onto one of the terminals on the
back of the ON/OFF switch on the gauge panel
4. Install the 30 amp fuse and fuse holder assembly. At one end
attach a female push on connector and the other end a blue butt
connector. Connect the fuse assembly to the accessory circuit
Technical Support
1-800-248-0892
Ext. 2
13
/
"
64
3
/
female
16

Advertisement

loading

This manual is also suitable for:

25655