Description Of Features - ConMed LS7700 Service Manual

Warning: Before taking the light source out
of stand-by mode, ensure that the output end
of the light guide or endoscope is not in
proximity to surgical drapes, flammable
objects, or to the patient's skin. Operating
room personnel or patient injury or burn
may result.
4. Press the BRIGHTNESS buttons to
set light output to the desired level.
OLED will display the set brightness
level.
5. To remove the light guide from the
LGR:
(a) Place the light source in stand-
by mode by pressing the
STAND-BY button.
(b) Fully rotate the Light Guide
Lever counterclockwise to the
OPEN position and remove the
light guide.
2.3

Description of Features

1. Light Source OFF:
• When the light source is in the OFF
condition, the POWER button LED
illuminates orange. Power will
continue to run to the unit, but the lamp
is not on.
• STAND-BY and BRIGHTNESS
buttons are inactive. Pressing the
POWER button will turn the Light
Source on.
• The OLED display is inactive.
2. Light Source ON, STAND-BY mode
enabled:
• When the light source is in the ON
condition, the lamp is on and the
POWER button LED and LGR
illuminate green.
• The OLED displays "STAND-BY" and
remaining Lamp Life Hours.
• The BRIGHTNESS buttons are
inactive.
• Pressing the POWER button will turn
the Light Source OFF.
• Pressing the STAND-BY button will
return the brightness level to its
previous setting and will allow light to
be emitted through the light guide.
3. Light Source ON, STAND-BY mode
disabled:
• When the light source is in the ON
condition, the lamp is on, the POWER
button LED illuminates green and the
LGR illuminates blue.
8