Table of Contents
Advertisement
Marquette Hellige GmbH
3.8
Recording test
The recording test is activated by pressing the "5" key.
A window with 2 channels is displayed.
- speed select key:
- start/stop key:
The selected speed and sensitivity is displayed.
Terminate with any key.
3.9
V24 tests
Several possibilities are available to test the serial interface. Moreover, on the one
hand, the signal transmission and receiving of the interface can be tested by an
internal feedback from TXD and RXD and, on the other hand, the signal transmission
and receiving with a remote station.
For the test with a remote station, the connection cable from MAC1100/1200 to PC,
PN 223 362 03 is required. In addition, the following transmission protocol should be
adjusted at the remote station:
1 start bit, 8 data bits, no parity
1 stop bit
Baud rate 19200
Pressing the "6" key calls up the following menu:
Interface test
1=
Sending and receiving
2=
Send test string to device
3=
Send/Receive with device
A = Abort
MAC 1100/1200 V 1.1
227 492 20 D - 0002
8 ROMB
- ROM error (checksum) in the FLASH
9 - not used
10 - not used
selects the speed
starts and stops a real time 2 channel recording
(terminate interface test)
Page 33
Advertisement
Table of Contents
