Table of Contents
Advertisement
Marquette Hellige GmbH
3.6
Test results
Pressing the "4" key triggers the output of the test results.
The output of the test protocol supplies the following information:
Time and date
Device serial number
Device model
Software release
ECG time constant
Battery voltage
test results
Memory used (ROM, RAM)
base address
size
Following output, the initial display menu reappears automatically.
The identification of the Hardware Version is given by the item "Remote Control
yes/no".
"No" indicates Hardware Version V 1.0 (no remote control), "yes" indicates
Hardware Version V 1.1.
This message is intended only for the use of the individual or entity to which it is addressed. As it contains
confidential information, any use distribution or copying is strictly prohibited if you are not the addressee.
3.7
Self-test
The test results elucidated in Section 3.6 are ascertained during the self-test, which is
always performed on power-up. Should errors be detected, a message appears on the
display after the test, indicating the possible errors. The following error codes are used
to identify the error.
Error codes
The following error codes appear on the display together with the message "Self-test
failed":
ERROR_CODES:
MAC 1100/1200 V 1.1
227 492 20 D - 0002
0 - reserved
1 VEKT
- error in vector table
2 DRAM
- DRAM error
3 SRAM
- SRAM error
4 - reserved
5 - reserved
6 - reserved
7 - reserved
Page 32
Advertisement
Table of Contents
