Jumper Settings; Install The Mainboard - MATSONIC MS9087C Manual

Jumper Settings

Connecting two pins with a jumper cap is SHORT; removing a
jumper cap from these pins, OPEN.
1
JP1
JP1: Clear CM OS Jumper
Use this jumper to clear the contents of the CMOS memory. You
may need to clear the CMOS memory if the settings in the Setup
Utility are incorrect and prevent your mainboard from operating.
To clear the CMOS memory, disconnect all the power cable s from
the mainboard and then move the jumper cap into the CLEAR
setting for a few seconds.
Function
Normal
Clear CMOS

Install the Mainboard

Install the mainboard in a system chassis (case). The board is an
ATX size mainboard. You can install this mainboard in an ATX
case. Make sure your case has an I/O cover plate matching the
ports on this mainboard.
Install the mainboard in a case. Follow the case manufacturer's
instructions to use the hardware and internal mounting points on
the chassis.
Jumper Setting
Short Pins 1-2
Short Pins 2-3
11