Pci/Plug And Play Setup Page - MATSONIC MS9087C Manual

Suspend Mode This item selects the status S1(Stop Clock)
or S3(Suspend to RAM) when the system
enters the power-saving Suspend mode.
This item sets up the timeout for Suspend
Suspend Time
mode in minutes. If the time selected passes
Out
without any system activity, the computer
will enter power-saving Suspend mode.
The system can be turned off with a
Resume On
software command. If you enable this item,
RTC Alarm
the system can automatically resume at a
fixed time based on the system's RTC
(realtime clock). Use the items below this
one to set the date and time of the wake-up
alarm. You must use an ATX power supply
in order to use this feature.
Your system can enter the software power
LAN/Ring
down. If you enable this item, the system
Power On
can automatically resume if there is traffic
on the network adapter.
If you enable this item, system can
Keyboard
automatically resume by pressing hot keys
Power On
on the keyboard or typing in the password.
You must enable the Keyboard Power On
jumper and use an ATX power supply in
order to use this feature.
PCI / Plug and Play Setup Page
This page sets up some parameters for devices installed on the PCI
bus and those utilizing the system plug and play capability.
CMOS SETUP UTILITY – Copyright (C) 1985-2003, American Megatrends, Inc.
Primary Graphics Adapter
Allocate IRQ to PCI VGA
PCI IDE BusMaster
PCI / Plug and Play Setup
AGP
Yes
Disabled
24
Help Item
Select which
graphics controller
to use as the
primary boot
device.