Advertisement
OPTIMUM
M A S C H I N E N - G E R M A N Y
Mount the mounting adapter to the milling machine.
Img. 3-5:
Adapter mounting
Slide the table feed onto the spindle.
Img. 3-6:
Table feed mounting
INFORMATION
Remove - if not already - the feather key out of the spindle.
Slide in the worm gear on the spindle.
Check the backlash of the gear. If necessary use the spacing plates and washers from the
accessory material to adjust the backlash.
When the backlash is set correctly, disassemble the worm gear again and lubricate the
worm gear with a commercial roller bearing grease.
Attach the feather key in the spindle.
Slide in the worm gear on the spindle again.
Fix the worm gear with the spindle nut.
Img. 3-7:
Worm gear mounting
Slide the scale ring onto the worm gear.
GB
V 99 S │V 250 S
Page 12
®
Bearing
Spindle
Worm gear
Spindle nut
Translation of the original instructions
Operation and mounting V250S
Version 1.0 dated 2019-01-31
Advertisement
