Input Power; Communication Wiring; Reader Wiring - Honeywell PW6K1ICE Installation And Configuration Manual

PW6K1ICE Wiring and Setup

Input Power

When erasing memory, LED 2 flashes at a 2 second rate; DO NOT CYCLE
POWER. It takes less than 60 seconds to erase the memory. LEDs 1 and 4 flash for 10
seconds after the memory has been erased. Then the PW6K1ICE reboots.

2.7 Input Power

The PW6K1ICE is powered by one of two ways (jumper selected, J3):
• The Ethernet connection using PoE, fully compliant to IEEE 802.3af, or
• Local 12VDC power supply, TB4-3 (VIN), TB4-4 (GND).
If the PW6K1ICE panel is powered by the local 12VDC, it must be powered by a UL
294/UL 609 Listed power supply with appropriate ratings (12VDC, 90 OmA) that is
capable of providing adequate standby power.
If the PW6K1ICE is powered by Power-Over_Ethernet (POE), it must be powered by
a Listed (ALVY) Altronix, Model NetWay1 POE Injector. NetWay1 must be powered
by a UL 294/UL 609 Listed power supply with appropriate ratings (24Vac/dc, 1.2A)
that is capable of providing adequate standby power.

2.8 Communication Wiring

The PW6K1ICE controller communicates to the host via the on-board 10-BaseT/
100Base-TX Ethernet interface (port 0).

2.9 Reader Wiring

The first reader port supports Wiegand, magnetic stripe, or 2-wire RS-485 electrical
interfaces.
The second reader port supports Wiegand or magnetic stripe electrical interfaces.
Power to the first reader is 12VDC and is current limited to 150mA. The second
reader may be powered from the auxiliary power output on TB4-1 and TB4-2.
Readers that require different voltage or have high current requirements should be
powered separately. Refer to the manufacture specifications for cabling requirements.
In the 2-wire LED mode, the Buzzer output is used to drive the second LED. Reader
port configuration is set via the host software.
The first reader port can support multiple multi-dropped RS-485 devices. If this
configuration is used, the second reader port will not support a third reader.
12 www.honeywell.com