Mount A A A Pump Mount Pump Without Pump Without - Graco SaniForce 2150 Operation

Mount the the Pump Pump
Mount Mount the Pump
For pumps that are provided with a stand, the pump
must be mounted to the stand before securing the
pump to the mounting surface. Ensure that the pump
is securely mounted to the stand.
The pump may be very heavy (see
Technical Specifications, page
weights). If the pump must be moved, follow the
Pressure Relief Procedure, page
people lift the pump by grasping the outlet manifold
securely, or use appropriate lifting equipment.
Never have one person move or lift the pump.
1. All pump models must be securely mounted to
the floor. Ensure that the mounting surface is
level and can support the weight of the pump,
lines, and accessories, as well as the stress
caused during operation.
FG pumps: pumps: Secure the pump with screws through
2. FG FG pumps:
the mounting feet and through the mounting
bracket or compressor box on the gear box.
See Dimensions (2150FG Pump), page 38
dimensions of mounting holes for your pump.
HS/3A/PH pumps: pumps: Ensure that the pump
HS/3A/PH HS/3A/PH pumps:
is securely mounted to the stand. Secure
the pump with screws through the mounting
bracket. Mount the pump and stand
assembly on a level surface and secure
the assembly to the mounting surface. See
Dimensions (2150HS/3A/PH Pumps), page
Dimensions (3000HS Flapper Pump), page
Dimensions (4000HS Flapper Pump), page 45
appropriate for dimensions of mounting holes for
your pump.
NOTE: NOTE: NOTE: For ease of operation and service, mount
the pump so the air valve cover, air inlet, and
fluid inlet and outlet ports are easily accessible.
NOTICE NOTICE NOTICE
To prevent pump damage, use all fasteners
in all mounting holes.
2150FG pump fasteners shown
3A5132M
47, for specific
23, and have two
for
41,
43, or
as
Mount a a a Pump Pump Without Without a a a Gearmotor
Mount Mount Pump Without
A pump without a Graco gearbox and motor will
require a mounting platform to provide support
for the customer-supplied motor and gearbox
and provide alignment with the pump alignment
housing (116) and drive shaft (112) without putting
strain on the mounting platform or pump. See
Dimensions (2150FG Pump), page 38
in fabricating a mounting platform.
REF REF REF DESCRIPTION DESCRIPTION DESCRIPTION
A
Gearbox coupler bore and
keyway
B Flange pilot diameter
C Bolt circle diameter
D Mounting hole thread size
To specify a non-Graco gearbox, refer to the figure and
table above.
Installation
Gearmotor
Gearmotor
for assistance
DIMENSION DIMENSION DIMENSION
35 mm/10 mm
keyway
110 mm
130 mm
M8 x 1.25
15