Typical Typical Installation; Installation - Graco SaniForce 2150 Operation

Typical Installation

Installation

Typical Typical Installation
Figure 1 Typical Installation for pumps without a
compressor
System Components Components
System System Components
B Fluid inlet port
Fluid outlet port
C
D Mounting feet
E Air inlet valve
P
Ground Screw
R Center Section Regulator
3A5132M
Accessories/Components Not
Accessories/Components Accessories/Components
A Power cord to VFD (required, not supplied)
F
Grounded, flexible air supply line (required, not supplied)
G Bleed-type master air valve
H Air regulator (required, not supplied)
J
Master air valve (for accessories)
K Flexible fluid suction line (required, not supplied)
L Fluid drain valve (may be required for your pump installation, not
supplied)
M Fluid shutoff valve (required, not supplied)
N
Flexible fluid outlet line (required, not supplied)
T Air pressure gauge (required, not supplied)
U Air line filter
Not Supplied Supplied
Not Supplied
Installation
13