Lighting Instructions - Pacific energy B Series Installation And Operating Instructions Manual

WARNING:
If you do not follow these instructions exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
- Do not try to light any appliance.
- Do not touch any electric switch; do not use any phone in
your building.
- Immediately call your gas supplier from a neighbour's
phone. Follow the gas supplier's instructions.
1. STOP! Read the safety information above on this page.
2. Set wall thermostat to lowest setting. (if applicable)
3. Turn off all electric power to the appliance.
4. Partially depress and turn gas valve knob clockwise
past "Pilot" to "Off" position.
Note: Knob cannot be turned from "Pilot" to "off" unless knob
is pushed in slightly. Do not force.
5. Allow sufficient length of time (minimum 5 minutes) for any
gas in the combustion chamber to escape. If you still smell gas,
STOP! Follow "B" in the safety information on above on this
page. If you don't smell gas, go to the next step.
6. Turn gas valve knob back to "Pilot" position.
7. Depress gas valve knob fully and hold while you ignite pilot
with the push button igniter. Once the pilot ignites, continue
depressing knob for approximately 5 seconds. If pilot does not
stay lit, repeat steps 4 through 7, allowing a longer period before
releasing gas valve knob.
- If gas control knob does not pop up when released, stop and
immediately call your service technician or gas supplier.
- If the pilot will not stay lit after several tries, turn the gas
1. Set wall thermostat to lowest setting. (if applicable)
2. Turn off all electric power to the appliance if service is to be
performed.
14
FOR YOUR SAFETY READ BEFORE LIGHTING

LIGHTING INSTRUCTIONS

TO TURN OFF GAS TO APPLIANCE
- If you cannot reach your gas supplier, call the fire depart-
ment.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
control dial to "Off" and call your service technician or gas
supplier.
8. Turn gas valve knob counter-clockwise
position.
9. Turn HI-LO burner control knob to desired setting.
10. Turn on all electric power to the appliance.
11. Set wall thermostat to desired setting. (if applicable)
Note: Sufficient time must be allowed for air to escape from lines
if the unit is being lit for the first time.
GAS VALVE
KNOB SHOWN
IN "OFF" POSITION
3. Push in gas control knob slightly and turn clockwise
to "Off". Do not force.
to "On"
GAS
VALVE