Setup/Wan-Module - ELSA Lancom DSL/10 Office Manual

R26 Description of the menu options
/Setup
DNS-module
Config-module
Time-module
Name Here you can enter the device name (maximum 16 characters). The set of characters
available includes uppercase and lowercase letters as well as some special characters.
You can display the full range of available characters during a configuration session by
entering the following command:
set \setup\name ?
In the default configuration, no name is entered.
The device name is required for identification purposes; it is a prerequisite for any
connection via the IP router module, since the routers can exchange data only with known
remote stations.
In the case of PPP connections, either the user name with the password from the PPP list
or the device name is transferred to the remote station as a device ID during a verification
by PAP or CHAP.
In addition, the device names you assign must be unique. For example, you might match
the device names to the location (e.g. Aachen, Berlin, Provider, etc.).

Setup/WAN-module

This menu groups together all the settings necessary for starting up the WAN interface
and controlling connections to logical remote stations.
/WAN-module
Name-list
PPP-list
Manual-dialing
Name-list The names entered in the name list are needed by the router to determine the correct
remote station and corresponding layer name. The name list is also used for the callback
function.
The name list can contain 16 different device names and might, for example, have the
following appearance:
Device-name
AACHEN
BERLIN
ELSA LANCOM DSL/10 Office
WAN settings
Remote station settings
Parameter settings for PPP connections
Settings for manual connection control
SH-time AC-name
180
20
System configuration
DNS server settings
Configuration module settings
Time module settings
Service
name