Table of Contents
Advertisement
Device Management
3.2 Configuring the Device
RJ45 Male
a
The DSR, RI and DTR pins are connected together internally.
b
The CTS and RTS pins are connected together internally.
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM i800 console and Web interfaces via the device's IP
address. For more information about available ports, refer to
(Page
Note
Single-mode fiber ports only support Ultra Physical Contact (UPC) cable connectors.
3.2
Configuring the Device
Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM i800 interface. For
more information about configuring the device, refer to the RUGGEDCOM ROS
Configuration Manual associated with the installed software release.
3.3
Inserting/Removing the MicroSD/MicroSDHC Card
The RUGGEDCOM i800 accepts a microSD/microSDHC card to support the following
features:
•
•
•
•
Configuration hazard – risk of data loss.
The microSD/microSDHC card must not be removed or replaced during normal
operation of the device. Make sure the device is powered down before removing or
inserting the card.
Mechanical/electrical hazard – risk of damage to the microSD/microSDHC card.
•
14
Pin
DB9 Female
8
7
17)".
Configuration update and backup
Redundant firmware image
Greatly expanded logging capability
Fault-tolerant firmware update
NOTICE
NOTICE
Do not expose the microSD/microSDHC car to extreme temperatures or
humidity.
Name
Description
b
RTS
Read to Send
Comment
"Communication Ports
RUGGEDCOM i800
Installation Manual, 01/2021, C79000-G8976-1002-06
Advertisement
Table of Contents
