Omron OMNUC W Series User Manual page 43

Chapter 5 The troubleshooting
■ ■ ■ ■ The parameter editing screen table display width malfunction
The servo driver connects with the monitoring software. But it is not displayed the servo
diver in " Select which Servo Driver to connect
【 Defective cause 】
・It occurs when control power typing by the servo driver is OFFd when the connector that
a communication cable was broken comes.
･The number machine No. setting by the connecting servo driver and the number
machine No. setting by the personal computer monitor software are different.
【 Handling 】
・Confirm the connection of the communication cable, control power typing by the servo
driver.
･Adjust number machine No. setting by the servo driver and the setting of the number
machine No. of the personal computer monitor software.
5-4