Omron OMNUC W Series User Manual page 31

Chapter 4 The way of operating
The operation to edit a parameter is as follows.
● ● ● ● The basic operation
It clicks 【Monitor/ Parameter Section】 from the 【View】 menu with the basic screen
and it makes display a servo data window.
It clicks a parameter tag in the servo data window and it displays a parameter editing
screen.
● The value entry type parameter The way of setting ●
● ●
To change a setting value, it does the following either operation.
・ " The setting value " Inputting direct value to the column.
・ " The setting value " Double-clicking a column.
It clicks an arrow and it sets value.
● ● The choice -type parameter
● ●
" Setting value " When clicking a column, a setting screen is displayed.
To change a setting value, it does the following either operation.
･ It chooses setting from the pull-down menu.
･ It clicks a check column and it puts a check mark.
( The setting becomes "1" when putting a check mark ).
The way of setting
4-5
key is displayed.
The choice -
type
parameter
The value
entry type
parameter