Piping And Tank - Xylem Goulds M05430 Instruction Manual

2.0 PIPING
2.0 PIPING
Notice: Most 4" submersibles have
left-hand discharge head threads,
hold the pump only at the
"discharge head" when installing
fittings or threaded pipe.
2.1 General
CAUTION
The pump discharge
piping should be sized
for efficient pump opera-
tion. Use the Friction Loss
Hazardous pressure can
cause personal injury
or property damage.
Tables to calculate total
dynamic head using different pipe
sizes. As a rule of thumb, use 1" for
up to 10 gpm, 1¼" for up to 30 gpm,
1½" for up to 45 gpm, and 2" for up
to 80 gpm. In the case of long pipe
runs it is best to increase pipe size.
Some pumps are capable of very high
discharge pressures, please select pipe
accordingly. Consult with your pipe
supplier to determine the best type of
pipe for each installation.
2.2 Pressure Tank,
DANGER
Pressure Switch
and Pressure
Relief Valve
Select a dry location in
Do not install tank where
it will be subjected to
which the ambient temper-
spray from irrigation
systems. Exposure to such
spray could result in
ature is always above 34º
corrosion of the tank,
eventually leading to an
explosion which can cause
F (1º C) in which to install
property damage, serious
personal injury or death.
the tank, pressure switch,
and pressure relief valve. The tank
should be located in an area where a
leak will not damage property.
The pressure switch should be
located at the tank cross tee and
never more than 4' from the tank.
Locating the switch more than
4' from the tank will cause
switch chatter.
Do not install valves, filters, or high
loss fittings between the switch and
the tank(s) as switch chatter may
result. As an example, a 1¼" spring
check valve has friction loss equal to
12' of pipe, placing the valve between
the pressure switch and the pressure
tank is the same as moving the pres-
sure switch 12' away from the tank. It
will create switch chatter.
On multiple tank installations the
switch should be as close to the cen-
ter of the tanks as possible. Multiple
tank installations should have a mani-
fold pipe at least 1½ times the size of
the supply pipe from the pump. This
will reduce the Friction Head in the
manifold and reduce the possibility
of switch chatter.
Pressure relief valves are required on
any system that is capable of
producing 100 psi or 230' TDH. If
blow-off may damage property,
connect a drain line to the pressure
relief valve and run it to a suitable
drain.
2.3 Adjusting Tank
Pre-Charge
Insure that the tank is empty of
water. Use a high quality pressure
gauge to check the tank pre-charge
pressure. The pressure should be 2 psi
below the pump cut-in pressure. As
an example, a 30-50 psi system would
use a tank pre-charge of 28 psi.
2.4 Discharge Pipe
Note: Most discharge heads are
threaded into the casing with left-
hand threads. Hold the pump only
at the discharge head when installing
fittings. Failure to hold the discharge
head will loosen it and pump damage
will result on start-up.
If your pipe requires an adapter we
strongly recommend using stain-
less steel. Galvanized fittings or pipe
should never be connected directly to
a stainless steel discharge head as
galvanic corrosion may occur. Plastic
or brass pumps can use any
material for this connection. Barb
type connectors should always be
double clamped.
7