Tilt Support Lever For Power Trim And Tilt Model; Cowling Lock Lever(S) (Turn Type); Flushing Device - Yamaha F60C Owner's Manual

A
1
2
1. Trim tab
2. Bolt
Bolt tightening torque:
F50F, F60C 18.0 Nm (1.8 kgf-m,
13 ft-lb)
FT60D 36.0 Nm (3.6 kgf-m, 26 ft-lb)
EMU26341
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
ECM00660
NOTICE
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
B
ZMU03097
ZMU03595
an additional support device to secure it
in the tilt position.
EMU26373

Cowling lock lever(s) (turn type)

To remove the engine top cowling, turn the
cowling lock lever(s) and lift off the cowling.
When installing the cowling, check to be sure
it fits properly in the rubber seal. Then lock
the cowling again by returning the cowling
lock lever(s) to the lock position.
1. Cowling lock lever(s)
EMU26461

Flushing device

This device is used to clean the cooling wa-
ter passages of the motor using a garden
hose and tap water.
1. Flushing device
TIP:
For details on usage, see page 64.
Components
1
ZMU05093
1
ZMU05095
25