Table of Contents
Advertisement
Operating instructions - SBU IO-Link
C)
Product description
C01
Use for the intended purpose
The SBU IO-Link is intended to be used in conjunction with pneumatic quarter turn actuators for valves. It
serves to detect the signals for the state "Open"/"Closed" or position 0° and 90°.
The SBU IO-Link is a microcontroller-assisted switch box. It has six interfaces.
These are:
- IO-Link communication interface for configuration of various parameters and direct access to process and
diagnostic data (the IODD required for operation of IO-Link and detailed description of the parameters can
be found at www.ebro armaturen.com)
- Connection terminals for the feedback signal OPEN/CLOSED & collective error
(exceeding the set operating parameters)
- Connection terminals for wiring of two solenoid valve coils
- Connection terminals for wiring external digital sensors (e.g. for the use of linear actuators)
- Connection terminals for wiring external analog sensors (standard signal 4-20mA)
- Bluetooth 4.0 interface for the visualisation of the operating states or the setting of the operating
parameters using the free EBRO Connect app (available in the Apple App Store and Play Store).
The mechanical adaptation to the pneumatic actuator is done directly at the connection point for positioners
and signal devices according to VDI/VDE 3845 AA2 80 mm x 30 mm and 30 mm shaft height (max. dia. 30
mm). Mounting kits according to VDI/VDE 3845 with different bracket dimensions are available for other
attachments.
The SBU IO-Link is used only in an area that is not potentially explosive.
The SBU IO-Link may only be put into operation after the following documents have been read:
-
<Explanation of the EU directives>
-
These assembly/operating instructions
Failure to observe this <intended purpose of use> represents gross negligence and relieves the
manufacturer EBRO-Armaturen of its product liability.
Page 22 of 50
Advertisement
Table of Contents
