Table of Contents
Advertisement
Operating instructions - SBU IO-Link
First aid facilities such as first aid kits, eyewash bottles, fire extinguishers, etc. are to be kept within reach!
Work may only be carried out on the SBU IO-Link by reliable, qualified personnel. The legal minimum age
must be observed!
Assign only trained or instructed personnel!
Personnel undergoing training, instruction or general education as well as apprentices may only work on
the SBU IO-Link under the constant supervision of an experienced, qualified person!
B05
Safety information for the operation of the SBU IO-Link
For all work that concerns the operation, retooling or adjustment of the SBU IO-Link and its safety devices,
as well as its inspection, maintenance and repair, the switch-on and switch-off procedures according to
these operating instructions and the information on maintenance must be observed!
The SBU IO-Link may only be put into operation in the assembled and ready-to-operate condition.
The SBU IO-Link is suitable only for operation in areas that are not at risk of explosion!
Before starting work, the personnel must familiarise themselves with the working environment around the
SBU IO-Link .
The SBU IO-Link must be checked for outwardly visible damage at regular intervals (at least once per
day). Changes (including in the operational behaviour) must be reported immediately to the responsible
foreman or the works manager.
Shut down and secure the SBU IO-Link immediately in case of malfunctions. Have malfunctions rectified
immediately by technical personnel who are trained for such work.
B06
Safety information for start-up/shutdown, service and maintenance
The operating personnel must be informed before special work and maintenance are carried out.
The prescribed intervals or those specified in the operating instructions for recurring checks, service or
maintenance must be adhered to.
Workshop equipment appropriate for the work is absolutely essential for carrying out the service and
maintenance tasks.
If necessary, illuminate service and maintenance areas with additional hand lamps or lamps mounted on
stands.
Secure the maintenance area if necessary!
To avoid electric shocks, do not touch any electrical components or damaged, torn and in particular live
parts.
During the setting and adjustment work, the support shaft with the end position cams and the remote
position indicator may rotate. Therefore, safe working on the SBU IO-Link must be ensured. An
appropriate safe distance must always be maintained.
Check the seals of the electrical housing regularly and replace them if necessary.
Clean the SBU IO-Link and its surroundings at regular intervals.
Screwed connections loosened during maintenance and repair work must always be tightened again
afterwards!
Do not stand or work under suspended loads.
If carrying out work at heights of 1.60 m or higher, safe climbing aids and working platforms or other such
equipment provided for this purpose are to be used! In the case of work platforms or work at heights
greater than 1.0 m, appropriate fall protection must be provided! Keep all grips, steps, railings, landings,
platforms and ladders free from dirt!
At the start of service, maintenance and care, free the SBU IO-Link from all dirt and residues such as oil,
operating materials or care products.
Do not use aggressive or solvent-based cleaning agents. Use lint-free cleaning cloths.
Use only water-based cleaning agents and observe the manufacturer's instructions. Do not use organic
solvents as there is a risk of fire and explosion!
Ensure safe and environmentally-friendly disposal of operating and auxiliary materials!
Page 16 of 50
Advertisement
Table of Contents
