Fisher Engineering SNOWPLOW Owner's Manual page 39

Automatic Shutdown
The control will automatically turn OFF after being
idle for 20 minutes. To reactivate the control after
a shutdown, press the ON/OFF button.
Optional Control Features
The control ships from the factory with the Smooth
Stop feature enabled and the one‑touch FLOAT
feature disabled. To change these default settings,
see "Smooth Stop" and "One‑Touch FLOAT" later
in this section of the Owner's Manual.
Control Functions
RAISE, LOWER, FLOAT, Angle
The four diamond‑shaped buttons in the center of
the control face, when pressed, will result in the
blade movements described in the table. For the
timeouts for each function by snowplow model,
see the Appendix.
Lit. No. 72446, Rev. 05
OPERATING YOUR SNOWPLOW
Function Description of Operation
Press this button to raise the blade and
RAISE
cancel FLOAT mode.
Press this button to lower the blade.
LOWER Release the button to stop the blade at
desired height.
Press the LOWER button and hold
3/4 second to activate this mode. The
FLOAT light in the upper right corner
of the control face will illuminate. The
blade will lower to the ground surface
and follow the contour of the surface as
FLOAT
†
it dips or raises. Function does not time
out; however, control will shut down after
20 minutes of nonuse.
Press the RAISE button momentarily to
cancel FLOAT. Angling left or right will not
interrupt (pause) the FLOAT function.
FLOAT mode activates immediately when one‑touch FLOAT
†
feature is enabled. See "One‑Touch FLOAT" in this section
for more information.
40 November 15, 2020