DAF CF65 Series Service Manual page 289

4
CF65/75/85 series
4.8 REMOVAL AND INSTALLATION, FUEL FILTER ELEMENT
}
When removing the fuel filter, a
quantity of fuel will escape. Collect
the fuel to avoid the risk of fire.
Removing the fuel filter element
1. Remove the cover together with the fuel filter
element from the filter housing.
Note:
The fuel filter element is a disposable filter,
and may not be cleaned and reused.
Dispose of the filter as chemical waste.
Fitting the fuel filter element
1. Replace the cover O-ring.
2. Fit the fuel filter element in the cover
3. Fit the cover with fuel filter element. Tighten
the filter cover to the specified torque. See
"Technical data".
4. Pump for approximately 1 minute using the
primer pump to partially fill the filter housing
with fuel.
5. Start the engine and run it at idling speed for
a few minutes; this will allow any air in the
filter housing to escape.
6. If the motor will not start up or runs very
erratically, the fuel system must be bled, see
"Draining and filling".
7. Check the fuel system for leaks.
©
200324
https://www.truck-manuals.net/
XE ENGINE FUEL SYSTEM
Removal and installation
i 400444
8
i 400445
4-15