DAF CF65 Series Service Manual page 143

4
series
10. Check that the oil supply and discharge
pipes are clean and not blocked, kinked or
cracked. Replace the pipes if necessary.
Note:
If the turbocharger oil supply and/or
discharge does not function properly, this
may result in serious damage to the
turbocharger and/or engine.
11. Fit new O-rings to the oil discharge pipe and
apply a thin layer of engine oil to them. Fit the
oil discharge pipe. For the specified
tightening torque, see "Technical data".
12. Pour clean engine oil into the oil supply of the
turbocharger and fit the oil supply pipe, after
fitting a new copper ring, on the oil filter
housing and the turbocharger. Tighten the
pipe to the specified tightening torque; see
"Technical data".
13. Fit the exhaust pipe to the turbocharger.
14. Fit the charge pipes to the exhaust pipe.
15. Fit the heat shield (1) to the oil filter.
16. Install the engine encapsulation (2).
©
200416
CE ENGINE INLET/EXHAUST SYSTEM
https://www.truck-manuals.net/
Removal and installation
1
2
i400857
3
4-3