Heater Unit Assembly And Dc Fan (Sirocco, 12 V) - Sony SNC-WR632C Service Manual

1-4-4. Heater Unit Assembly and DC Fan (Sirocco, 12 V)

1. Remove the cabinet. (Refer to Section 1-3.)
2. Remove the TILT block. (Refer to Section 1-4-3.)
3. Remove the two screws (PSW2.6 x 6), then remove the two cable clamps.
4. Remove the all harnesses from the two cable clamps.
5. Remove the two screws (PSW2.6 x 8), then remove the heater unit assembly and fan bracket.
6. Remove the two screws (PSW4 x 20), then remove the DC fan (sirocco, 12 V).
7. Remove the other heater unit assembly and DC fan (sirocco, 12 V) in the same procedure as steps 5
and 6.
PSW2.6
Fan bracket
8. To install, reverse the removal procedure.
n
When attaching the DC fan (sirocco, 12 V), attach it with the label side faced toward the out cabinet.
1-12 (E)
8
Heater unit assembly
PSW4 20
Harnesses
PSW2.6
Label
side
DC fan
(sirocco, 12 V)
Heater unit assembly
DC fan
(sirocco, 12 V)
Label side
Cable clamp
PSW
2.6 6
Harnesses
6
PSW4
Cable clamp
PSW2.6 8
Fan bracket
20
Out cabinet
SNC-WR632C/WR602C