Preparation
1. Connect each equipment according to the connection diagram in Section 2-1-1.
2
Turn on the power of each equipment and wait until the image is displayed on the video monitor.
3. Make sure to make a copy of the software "G6 Serial_Inputter For Service" including in MAC/Serial
writing tool in an arbitrary folder in the PC.
4. Install the SNC toolbox to PC.
5. Start the SNC toolbox.
The information of this unit is displayed.
n
If it is not displayed, click the [Search] button.
[Search] button
6. Double-click the information display portion of this unit.
The viewer screen is displayed.
[Setting] button
SNC-WR632C/WR602C
Information is displayed for
each model.
Double-click this portion.
2-3 (E)