Rear Assembly - Sony Ipela ExwavePRO SNC-CS20 Service Manual

1-3-2. Rear Assembly

n
Replace the removed tape (A) with the new tape (A).
. Parts name:
Tape (A)
. Parts number: 3-941-343-01
1. Remove the lens. (Refer to Section 1-2.)
2. Remove the upper case. (Refer to Section 1-3-1.)
3. Remove the tape (A).
4. Remove the screw (B2 x 6) and the two screws
(PSW2 x 5).
5. Disconnect the six harnesses from the connectors
(CN801, CN804, CN805, CN807 and CN808) on the
SY-365/365A board and the connector (CN901) on the
CN-3107 board.
6. Remove the rear assembly and SY-365/365A board in
the direction of the arrow.
7. Disconnect the harness from the connector (CN902)
on the CN-3107 board.
8. Remove the two screws, then remove the rear assem-
bly in the direction of the arrow.
9. To install, reverse the removal procedure.
n
When attaching, align the two holes of the SY-365/
365A board with the two dowels of the rear assembly.
SNC-CS20/CM120
Tape (A)
Tape (A)
Harness
CN808
CN801
PSW2 x 5
SY-365/365A
board
Harnesses
Holes
PSW2 x 5
SY-365/365A
board
Harness
Rear assembly
CN808
CN804
CN901
CN807
CN805
Harness
Harnesses
CN-3107
board
B2 x 6
CN902
Dowel
Rear
assembly
Dowel
CN-3107 board
1-3