Basic Installation And Connections; Installing The Unit; Before Installation; Installing The Camera - Sony SNC-DF40N Installation Manual

Basic Installation and Connections

B

Installing the Unit

Using the supplied screws, you can attach
the camera to the ceiling or the wall.
Notes
• If you attach the unit to the ceiling or the
wall, entrust the installation to an
experienced contractor or installer.
• If you install the unit on the ceiling or the
wall, be sure the ceiling or the wall is
strong enough to withstand the weight of
the camera. If the ceiling or the wall is not
strong enough, the unit may fall and cause
serious injury.
• If you attach the unit to the ceiling or the
wall, check periodically, at least once year,
to ensure that the connection has not
loosened. If conditions warrant, make this
periodic check more frequently.
• Take care not to stain, strike or press hard
on the lens cover. Such acts may inhibit
optimum performance of the camera and
may cause a malfunction.

Before installation

• After deciding the direction in which the
camera will shoot, make the required holes
for the connecting cables.
• The lens of the camera is protected by a
sheet for transport. Before installation,
remove the lens cover, then remove the
sheet.
Mounting screws
The supplied stand is provided with two ø 5
7
mm ( / inch) mounting holes. Install the
32
stand to a ceiling or wall with screws
through these holes.
The required mounting screws differ
depending on the installation location and its
material.
Steel wall or ceiling: Use M4 bolts (not
supplied) and nuts.
Wood wall or ceiling: Use the supplied M4
tapping screws. The panel thickness must be
15 mm (5/8 inch) or more.
Concrete wall: Use appropriate anchors,
bolts and plugs (not supplied) for concrete
walls.
Junction box: Use screws (not supplied) to
match the holes on the junction box.

1 Installing the Camera

1
Remove the dome cover.
There are three embossed marks
the camera around the dome cover. Hold
and push the cover at the two points
corresponding to two of these marks,
and remove the cover from the camera.
2
When installing on a ceiling or wall,
fix the supplied wire rope to the
bottom of the camera and the ceiling
(or wall).
Fix the wire rope to the ceiling or
1
wall.
2 Remove the screw on the bottom of
the camera, and string the screw
through the hole of the wire rope.
Then secure the screw firmly so that
it will not come loose.
Ceiling
+ DC 12V
1 2 3 4 5 6 2 AC 24V
+
2
3
Install the camera on the ceiling or
wall with the two supplied screws.
Installing the Unit
A on
A
– 5
m
1
Wire rope
–
DC 12V 5
m
AC 24V 1
13
GB