Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
9)
After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.
10) Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f For restrictions on character strings that can be set for password, refer to [PASSWORD POLICY] ( x page 56).
f By pressing the <MENU> button while the [ADMINISTRATOR ACCOUNT] screen is displayed, you can proceed to the next operation
without setting an administrator account password, but the network function of this projector cannot be used. To use the web control function
or the communication control (including operation with application software) via LAN, set a password.
f If you press the <MENU> button while the [ADMINISTRATOR ACCOUNT] screen is displayed, the [ADMINISTRATOR ACCOUNT]
screen will not be displayed the next time the power is turned on. To use the network function, set a password in the [NETWORK] menu →
[ADMINISTRATOR ACCOUNT].
f The user name and password of the administrator account can also be changed on the [Set up password] page ( x page 159) of the web
control screen.
f The user name and password of the standard user account without administrator rights can be set on the [Set up password] page
( x page 159) of the web control screen.
Making adjustments and selections
It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
1)
Press the <FOCUS> button to roughly adjust the focus of the projected image. ( x page 60)
2)
Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. ( x page 33)
f Refer to "Navigating through the menu" ( x page 71) for the operation of the menu screen.
3)
Set [LENS TYPE].
f Confirm the setting of the lens type when using the projector for the first time after replacing the projection
lens. ( x pages 61, 117)
4)
Select the input by pressing the input selection button on the remote control or the control panel.
f The buttons that can be used on the remote control or the control panel are as follows.
Remote control:
<HDMI 1> button, <HDMI 2> button, <HDMI 3> button, <COMPUTER> button, <DIGITAL LINK> button
Control panel:
<INPUT SELECT> button
f For details of operation for input selection, refer to "Selecting the input signal" ( x page 59).
5)
Adjust the front, back and sideway tilt of the projector with the adjustable feet. ( x page 62)
6)
Press the <SHIFT> button to adjust the position of the projected image. ( x page 60)
7)
If the input signal is the analog RGB signal, press the <AUTO SETUP/CANCEL> button to
automatically adjust the projection position.
8)
Press the <ZOOM> button to adjust the projected image size to match the screen.
2)3)
5)
1) 9)
4)
1) 6) 8) 9) 10)
ENGLISH - 57
7)
6)
8)10)
2)3)
4)
Advertisement
Table of Contents
