Table of Contents
Advertisement
Setting up
Installation mode
The installation modes of the projector are as follows. Set [FRONT/REAR]/[FLOOR/CEILING] in the [PROJECTOR
SETUP] menu → [PROJECTION METHOD] ( x page 107) depending on the installation mode.
Setting on a desk/floor and projecting forward
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Mounting on the ceiling and projecting forward
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Portrait setting and projecting forward
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Note
f In the portrait setting, the on-screen menu is displayed sideways.
To display the on-screen menu vertically, go to the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] ( x page 99) and change the
[OSD ROTATION] setting.
f The projector has a built-in angle sensor. The attitude of the projector is automatically detected by setting [FLOOR/CEILING] to [AUTO] in
the [PROJECTOR SETUP] menu → [PROJECTION METHOD].
Chapter 2 Getting Started — Setting up
Setting value
[FRONT]
[AUTO] or [FLOOR]
Setting value
[FRONT]
[AUTO] or [CEILING]
Setting value
[FRONT]
Set in accordance with the image
to project.
Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Portrait setting and projecting from rear
(Using the translucent screen)
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Setting value
[REAR]
[AUTO] or [FLOOR]
Setting value
[REAR]
[AUTO] or [CEILING]
Setting value
[REAR]
Set in accordance with the image
to project.
ENGLISH - 33
Advertisement
Table of Contents
