Table of Contents
Advertisement
f The [PASSWORD] screen is displayed.
6)
Press asqw to select a character, and press the <ENTER> button.
f Enter the password of the administrator account.
7)
After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [COMMAND PROTECT] screen is displayed.
8)
Press asqw to select [OK], and press the <ENTER> button.
Note
f When [COMMAND PROTECT] is set to [DISABLE], connection authentication is not performed, making it vulnerable to threats on the
network. Be aware of the risks before making settings.
f For details on how to use the command control function, refer to "Control commands via LAN". ( x page 188)
[NETWORK CONTROL]
Set the network control of this projector.
Setting the password of the administrator account ( x page 137) is required for using the network function of the
projector.
1)
Press as to select [NETWORK CONTROL].
2)
Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3)
Press as to select an item, and press qw to change the setting.
[WEB CONTROL]
[COMMAND CONTROL]
[COMMAND PORT]
[Crestron Connected(TM)]
[AMX D.D.]
4)
Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
5)
Press qw to select [OK], and press the <ENTER> button.
Note
f If the password of the administrator account has not been set, that is, if it is left blank, the network function of this projector cannot be used.
Set a password before using the web control function or the communication control (including operation with application software) via LAN.
[PJLink]
Set the PJLink function to control and monitor the projector using the PJLink protocol.
Setting the password of the administrator account ( x page 137) is required for using the PJLink function of the
projector.
Note
f If the password of the administrator account has not been set, that is, if it is left blank, the network function of this projector cannot be used.
Set a password before using the web control function or the communication control (including operation with application software) via LAN.
[PJLink PASSWORD]
Set the password for security authentication which is required when connecting to the projector.
1)
Press as to select [PJLink].
2)
Press the <ENTER> button.
f The [PJLink] screen is displayed.
3)
Press as to select [PJLink PASSWORD], and press the <ENTER> button.
140 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
Set to [ON] to control with the web browser.
Set to [ON] to control with the control command format ( x page 194) for the <SERIAL/MULTI SYNC
IN> terminal. Refer to "Control commands via LAN" ( x page 188).
Set the port number used for command control.
Set to [ON] to control with Crestron Connected of Crestron Electronics, Inc.
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through "AMX Device Discovery". For details, visit the
website of AMX Corporation.
URL http://www.amx.com/
Advertisement
Table of Contents
