Table of Contents
Advertisement
r Top
18
Projection direction
1
Remote control signal receiver (front)
2
Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
3
Light source indicator <LIGHT>
Indicates the status of the light source.
4
Temperature indicator <TEMP>
Indicates the internal temperature status.
5
Filter indicator <FILTER>
Indicates the status of the air filter unit.
6
Projection lens
7
Adjustable feet
Adjusts the projection angle.
8
Intake vent
9
Control panel ( x page 29)
10 Exhaust vent
11 Connecting terminals ( x page 30)
Attention
f Do not block the intake and exhaust vents of the projector.
The components may deteriorate faster if cooling inside the projector is inhibited.
r Control panel
1
Power < v / b > button
( v : Standby, b : Power on)
Sets the projector to the state where the projector is turned
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
Sets the projector to projection mode when the power is switched
off (standby mode).
Chapter 1 Preparation — About your projector
19
1
2
3
4
5
r Bottom
12 <MAIN POWER> switch
Turns on/off the main power.
13 <AC IN> terminal
Connect the supplied power cord.
14 Power cord holder
15 Security slot
This security slot is compatible with the Kensington security
cables.
16 Remote control signal receiver (rear)
17 Air filter cover
There is the air filter unit inside.
18 Luminance sensor ( x page 79)
19 Top slide cover
There is the lens lock lever for mounting the projection lens
inside. ( x page 41)
20 Burglar hook port
Attaches a burglar prevention cable, etc.
6
3
7
8
2
<MENU> button
Displays or hides the main menu. ( x page 71)
Returns to the previous menu when a sub-menu is displayed.
3
<VOL-> button/<VOL+> button
Adjusts the volume of the audio output. ( x page 64)
4
<SHUTTER> button
Used to turn off the image and audio temporarily. ( x page 63)
20
ENGLISH - 29
Advertisement
Table of Contents
