Vap Configuration Using Snmp - Cisco AP541N-A-K9 Administration Manual

8
STEP 8
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 10
STEP 11
STEP 12
159
Click Apply to update the access point with the new settings.

VAP Configuration Using SNMP

Load the FASTPATH-WLAN-ACCESS-POINT-MIB module.
From the MIB tree, navigate to the objects in the apVap table.
Walk the apVapDescription object to view the instance ID for VAP 2 (wlan0vap2).
VAP 2 on wireless Radio 1 is instance 5.
Use the apVapStatus object to set the status of VAP 2 to up (1).
Use the apVapVlanID object to set the VLAN ID of VAP 2 to 2.
Navigate to the objects in the apIfConfig table.
Walk the apIfConfigName object to view the instance ID for VAP 2 (wlan0vap2).
VAP 2 on wireless Radio 1 is instance 7.
Set the value of instance 7 in the apIfConfigSsid object to Marketing.
Set the value of instance 7 in the apIfConfigSecurity object to wpa-personal (3).
Set the value of instance 7 in the apIfConfigWpaPersonalKey object to
JuPXkC7GvY$moQiUttp2, which is the WPA pre-shared key.
Navigate to the objects in the apRadioBss > apBssTable table.
Walk the apBssDescr object to view the instance ID for VAP 2.
VAP 2 on wireless Radio 1 is instance 3.
Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide
Configuration Examples
Configuring a VAP