Inlet Catchpot; Inlet Dust Filter; Inlet Desiccant Trap; Inlet Chemical Trap - Edwards E2M28 Instruction Manual

Accessory
PV25EK Valve: 110/127 V, 1-phase, 50/60
Hz
FL20K foreline trap
Vibration isolators (pack of four)
ODE 1/4 Oil drain extension
Pump inlet adaptor
Flexible bellows
Pump outlet adaptor
Gas ballast banjo elbow assembly
Gas ballast valve: 110 V, 50/60 Hz
Gas ballast valve: 240 V, 50/60 Hz

10.3.1 Inlet catchpot

The inlet catchpot traps any liquid droplets and prevents their entry into the pump.

10.3.2 Inlet dust filter

The inlet dust filter protects the pump against abrasive dust.

10.3.3 Inlet desiccant trap

Use a desiccant trap when pumping limited quantities of water vapour at high pumping
speeds to a low vapour pressure.

10.3.4 Inlet chemical trap

The inlet chemical trap protects the pump against chemically active gases.

10.3.5 Outlet mist filter

The outlet mist filter separates and traps oil droplets in the pump outlet to prevent oil
mist discharge. The mist filter is supplied with an adaptor to connect it to the pump
outlet.

10.3.6 Solenoid operated pipeline valve

Fit the pipeline valve between the vacuum system and the pump inlet to provide
additional system protection when the pump is switched off.

10.3.7 Foreline trap

Use a foreline trap on a clean pumping system to prevent back-migration of rotary pump
oil vapour into the vacuum system.
A37310880_V - Spares and accessories
Page 46
Item number
C41303000
A13305000
A24801412
A50503000
C10520201
C10511670
C10501414
A50006003
A50006984
A50006930