Accessories; Inlet Dust-Filter; Inlet Catchpot; High-Capacity Inlet Dust-Filter - Edwards E2M175 Instructions Manual

A366-04-880 Issue A
7.4

Accessories

A range of accessories are available for the E2M175 and E2M275 pumps.
7.4.1

Inlet dust-filter

The inlet dust-filter is a nylon-fibre filter-element which protects your pump against abrasive dust (see
1). You can check the filter-element by looking through a glass cover at the top of the filter. The filter is supplied
with bolts, washers and 63 mm co-seal.
Product
ITF300 Inlet Dust Filter
7.4.2

Inlet catchpot

The inlet catchpot traps liquid droplets and prevents their entry into the pump (see
the liquid level in the catchpot by looking through a glass cover at the top of the catchpot. The catchpot is supplied
with bolts, washers and 63 mm co-seal.
Product
ITO300 Inlet Catchpot
7.4.3

High-capacity inlet dust-filter

The high-capacity inlet dust-filter (see
pump down times and where high levels of dust and grit are involved. You can check the filter-element by looking
through a glass cover at the top of the filter. The filter is supplied with bolts, washers and 63 mm co-seal.
Product
ITM300 High Capacity Dust Filter
7.4.4

Inlet chemical-trap

The inlet chemical-trap (see
your pump or pump oil. You must provide the trapping material suitable for your application. The trapping material
is contained in a removable fine mesh container supplied with the inlet chemical-trap. You can check the chemical-
trap by looking through a glass cover at the top of the chemical trap. The chemical trap is supplied with bolts,
washers and 63 mm co-seal.
Product
ITC300 Inlet Chemical Trap
7.4.5

Outlet catchpot

If your pump outlet is piped for remote discharge, condensed pipeline vapour could drain back to your pump. The
outlet catchpot (see Figure
drain the catchpot. The catchpot is supplied with two ISO40 'C' clamps, ISO40 elbow, two 40 mm centring rings and
O-rings, bolts, washers, mounting bracket and studs.
Product
CP300 Outlet Catchpot
Page 30
Figure 8, item 1) is a wire mesh filter. You use this filter where you have fast
Figure 8, item 1) protects your pump against chemically active gases which may attack
8, item 3) collects the liquid. You can see from a sight-glass indication when you need to
Edwards and the Edwards logo are trademarks of Edwards Limited.
Item Number
A442-03-000
Figure
Item Number
A441-03-000
Item Number
A443-03-000
Item Number
A444-03-000
Item Number
A461-04-000
© Edwards Limited 2014. All rights reserved.
Figure 8, item
8, item 1). You can check