Removing Pto Gear; Removing Oil Pump; Removing Relief Valve; Removing Governor Shaft And Speed Control Lever - Mitsubishi L Series Service Manual

DISASSEMBLY OF BASIC ENGINE

3.5 Removing PTO gear

Pull out the PTO gear together with two ball bearings from
the gear case.

3.6 Removing oil pump

Remove the oil pump housing from the gear case, and then
remove the oil pump outer gear and oil pump inner gear.

3.7 Removing relief valve

(1) Remove the plug from the gear case.
(2) Remove the oil relief spring and relief plunger.
3.8 Removing governor shaft and speed
control lever
(1) Remove the sealing cap from the side of the gear case.
(2) Pull out the grooved pin A.
(3) Remove the governor shaft.
(4) Remove the tension lever and governor lever.
(5) Remove the governor spring lever.
(6) Remove the grooved pin B.
(7) Remove the speed control lever.
(8) Remove the governor cover.
5-10
Ball bearing
Removing PTO gear
Oil pump inner gear
Gear case
Removing oil pump
Relief plunger
Gear case
Removing relief valve
Speed control
lever Governor shaft cover
Grooved pin B
Governor spring lever
Governor lever
Grooved pin A
Removing governor shaft and
speed control lever
PTO gear
Oil pump housing
Oil pump outer gear
Relief
Plug
spring
Tension lever
Sealing cap
Governor shaft
Gear case