Reassembling Fuel Injection Pump; Installing Plunger Barrel - Mitsubishi L Series Service Manual

2.5 Reassembling fuel injection pump

4.9 to 6.9 N m
{0.5 to 0.7 kgf m}
[3.6 to 5.1 lbf ft]
9.8 to 14.7 N m
{1.0 to 1.5 kgf m}
[7.2 to 10.8 lbf ft]
2.5.1

Installing plunger barrel

Align the plunger barrel groove with the knock pin of the
pump housing, and insert the pluger barrel into the pump
housing.
Note: If the knock pin is not aligned with the plunger barrel
groove, the plunger barrel will not be installed
correctly. Make sure that O-ring is not protruded from
the pump housing when the delivery valve holder is
snugly tightened.
3.2 to 4.0 N m
{0.3 to 0.4 kgf m}
[2.2 to 2.9 lbf ft]
Reassembling fuel injection pump
3.2 to 4.0 N m
{0.3 to 0.4 kgf m}
[2.2 to 2.9 lbf ft]
Plunger barrel
Control rack
side
Viewed from above
Inserting plunger barrel
FUEL SYSTEM
34.3 to 38.2 N m
{3.5 to 3.9 kgf m}
[25.3 to 28.2 lbf ft]
Groove
Pump housing
Knock pin
8-15