Adjusting The Position Of The Hand Switch; Related Information - Brother Z-8550B Instruction Manual

Adjusting the position of the hand switch

The installation position of the hand switch (1) can be
adjusted as shown in the illustration. Adjust so that it is
in a position where it is easy to operate.
(Z-8560B)
If using a thread wiper device, adjust the position of
the hand switch (1) within the range of (A) so that it
does not touch the thread wiper.
1
Loosen the two screws (2).
2
Move the switch setting base (3) to move the hand
switch (1) to the preferred position.
3
Tighten the two screws (2).

Related Information

• Points to note when making adjustments on page 103
Rear
104