Permobil X850 Corpus 3G User Manual page 90

X850 Corpus 3G
4.1.7.2 Leg support length
The leg support length is adjustable continuously and secured using
two locking screws.
1. Remove the leg support cover.
2. Undo the leg support's two inner locking screws.
3. Adjust the leg support to the required length and secure by
tightening the locking screws.
4. Check that the leg support is fully secured.
5. Re-fit the leg support cover.
WARNING!
Risk of injury – adjust floor-to-footplate
clearance
After adjustment, and with the seat lift in its lowest position, make sure there
is sufficient clearance, at least 25 mm, between the ground and the
footplate at all times when moving the leg support in or out. Perform this test
with the user sitting in the wheelchair with his or her feet on the footplates.
90
Preparing for use
Figure 55. Adjustment screws for leg support cover.