Unpacking And Inspection; Storage - Thermo Scientific 60-12 Operating And Service Manual

1.1.1 Application
The speed sensor is coupled to a rotating shaft which drives a generator inside the
housing. the Model 60-12C Speed Sensor has a useable range between 20 and 200
RPM. The 60-12F is used for speeds from 3 to 30 RPM, and the 60-12G is used for
speeds from 10 to 200 RPM. The 60-12 ENC Speed Sensor has a 500 pulse per
revolution encoder inside, typically is used on slow RPM applications, and has a
range of 0 to 200 RPM. The frequency of the speed sensor output signal is exactly
proportional to shaft speed and provides the required speed input to a Thermo
Scientific Integrator/Totalizer.
1.2

Unpacking and Inspection

The Model 60-12 Speed Sensor has been properly packaged and inspected prior to
shipment. Before unpacking, be certain to check the package for external damage,
as the carrier may often times be held responsible for shipping damage.
1.3

Storage

The Model 60-12 Speed Sensor can be safely stored indoors, with hole plugs
installed, between -50 and +70 degrees C (-58 to +158 degrees F). The unit must be
protected against moisture.
2 REC 3016 Rev M