Table of Contents
Advertisement
11.3.2
11.4
11.4.1
0312582_EcoSword_V4.0, 03-05-2021
Clean the condensate drain
To clean the condensate drain:
1.
Place a tray or towels under the condensate drain to collect water leakage.
2.
Remove the condense trap at the bottom of the condensate drain.
3.
Empty the condense trap and clean it with water.
4.
Make sure that there is no grit or other blockages in the condense trap.
5.
Make sure that there is no grit or other blockages in the condensate drain.
6.
Make sure that there is no grit or other blockages in the drain pipe.
7.
Make sure that the slope of the drain pipe is correct; 5 mm/m.
8.
Install the condense trap onto the condensate drain.
Fig. Condensate drain
!
Gas-side maintenance
Do gas side maintenance when the water heater does not operate correctly, the air
pressure differential is not correct and/or the CO
To do gas side maintenance:
•
Clean the burner (see 11.4.1)
•
Clean the combustion chamber (see 11.4.2)
Clean the burner
Remove the burner engine:
1.
Close the gas control valve, refer to Installation diagram (see 8.3).
2.
Disconnect all plugs from the burner engine (1).
3.
Disconnect the gas supply pipe (2).
1. Condensate drain
2. Condense trap
3. Drain pipe
value is not correct.
2
63
Hide quick links:
Advertisement
Table of Contents
