Instructions On The Water Heater - Lochinvar EcoSword LGC 160-210 G P CE Installation, Commissioning, User & Maintenance Instructions

Ecosword gas fired condensing water heater
Table of Contents

Advertisement

n
6.2
30
Caution
To prevent that you damage the components of the water heater, make sure that it is
completely stopped operation before you turn off the water heater (see 4.3). Wait 1
minute after you switch the water heater to OFF mode, before you switch the control
switch to 0.
Caution
The anode protection remains active when the water heater is in OFF mode and the
control switch is set to 0.
Note
Any leakage from the tank and/or connections can cause damage to the immediate
environment or floors below the level of the boiler room. Install the water heater above a
waste water drain or in a suitable metal leak tray.
The leak tray must have an appropriate waste water drain and must be at least 5 cm
deep with a length and width of at least 5 cm larger than the water heater.

Instructions on the water heater

The water heater has some safety instructions on its cover:
The text "Read the installation instructions before installing the appliance".
The text "Read the user instructions before putting the appliance into operation".
Also the packaging has some safety instructions:
The text "Read the installation instructions before installing the appliance".
The text "Read the user instructions before putting the appliance into operation".
The text "The appliance may only be installed in a room that meets the required
ventilation regulations".
Some safety pictograms:
CE approved
this way up
fragile
keep dry
maximum stacking height is 1
do not use a trolley
do not use a clamp truck
recycled packaging
Installation, Maintenance and Service part

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents