Lochinvar EcoSword LGC 160-210 G P CE Installation, Commissioning, User & Maintenance Instructions page 49

n
Control switch ON mode/
OFF mode
(parameter 001)
Position 0 -
(OFF)
Position I OFF mode
(ON)
ON mode
n
0312582_EcoSword_V4.0, 03-05-2021
3. Install the cables in a pull relief under the electrical section.
4. Set the appropriate settings in the interface.
Note
Use parameter 002 or 005 to set the ON mode setpoint. The parameter to be used
depends on the value of parameter 004, refer to the table below.
External
ON mode
switch
-
Open
Closed
Open
Closed
8.8.3.3 Additional error signal
Note
The water heater has a relay contact that can be used when an error occurs. The relay
contact is potential–free (maximal 5 A).
Note
There is a 1 minute delay between the switching of the relay contact and the error
message on the display.
Install an additional error signal:
1. Pull the power cable through the tulles.
2. Connect the cables to X1 and X2.
3. Install the cables in a pull relief under the electrical section.
Setpoint EXT mode Result
(parameter 004)
- No functionality
(Anode protection active)
- Frost protection
Disabled (dIS) EXT mode
(set setpoint with parameter 002)
Enabled (ENA) EXT mode
(set setpoint with parameter 005)
- ON mode
(set setpoint with parameter 002)
Disabled (dIS) EXT mode
(set setpoint with parameter 002)
Enabled (ENA) EXT mode
(set setpoint with parameter 005)
49